The Purpose of Installing Gutter Guards

Having your gutters cleaned and installed with DIY Gutter Guards can significantly increase the value of your home. They’re not expensive, and there are many available on the market.

You may think that gutter guards are only for owners of homes that are built before the 1950s. That is not true. Nowadays, the homeowner can freely pick from a variety of modern styles and get their gutter guards installed without the expense and hassle of digging up the foundation.

Installing your guard is very easy. First, measure the length of your gutters and determine the level of their clearance. Then, mark where you want the guard to be installed. Next, you ought to decide whether you want the guard to be mounted on the inside or outside.

The outside option is usually the cheapest, but it does require drilling holes into the structure. If you have wood shakes or boards on the exterior of your home, it may be best to simply sand down these and have them replaced with metal shingles. A gutter guard that goes on the outside will catch any debris or snow that doesn’t fall off the roof.

Once you have the proper measurements and tools set up, the installation process is quite simple. All you must to do is place the guard at the level you want it to be, then secure it in place with screws.

If you are installing it on the inside, put down some felt paper to help keep the guard in place. You will need a couple of people to help when installing the guard. It may also be a good idea to install a step stool to walk your way around and remove debris before the guard is even installed.

Install the DIY Gutter Guards over the highest point of the gutter and screw into the wall for support. Then, screw on the bottom and leave it in place. Then it is time to install the base, which can be done by hand or with a large wrench. Using the bottom is not recommended because it can crack if not installed properly.

After all of the screws are secured, allow the install to rest for a day or two to give it time to completely dry. Next, take the guard down and take a look. Check for clogs and if you have an exterior grade product, scrape out any debris with a wire brush and a broom. One more alternative is to use a pressure washer to flush out the problems and get everything clear of debris.

If you have a window that leaks, a vacuum will help to make the job easier. By cleaning the debris from the edge of the guard, you will make the grout lines to look great and eliminate any dirt that will cause problems in the future.

When the guard is installed, allow it to sit and dry for several days to a week, depending on how much it needs to be cleaned. Then, remove it and wipe it down. Another option is to wash it with soap and water and allow it to air dry.

You should never use a commercial cleaner, as this could ruin the guard and leave a rusty spot that will reduce its life span. When you’re ready to install the guard again, take a stiff brush away the dust, which could make the installation process easier.

When you are over with the installation process, inspect the guard for any cracks or damage. If you find any cracks, it is a good idea to take it back to the hardware store for repair.

You can shop for premium quality DIY Gutter Guard Kits Online by clicking this link.